|
| TEL +44
(0)1329 832621 |
| FAX +44
(0)8704 603348 |
| |
|
Dynalab Getting Started & Choosing Your System |
UP |
| Getting
started with the NX System is as simple as selecting an NX Tester, ordering
the Getting Started Kit, and selecting the appropriate fixture interface
method. |
|
 |
 |
 |
|
NX Solo
256 Test Points |
NX Pro
512 Test Points |
NX Pro+
32,768 Test Points |
|
Essential Items
Dynalab has created a Getting Started Kit that includes all items required
for a Dynalab System. This kit includes:
- NX Editor and Download Cable
- Memory Card
- Memory Card Reader/Writer
- Supervisor Key
- Probe, 8'
|
|
Fixture Interfacing
NX System test point boards provide 128 test points per board, organized
into 2 groups of 64 points each. Each group of 64 test points is accessible
from the back of the Tester. A card edge connector is used to interface to a
set of 64 test points. The card edge connector may be equipped with discrete
wires or with a ribbon cable. Choose either discrete wire interfacing or
ribbon cable.
A discrete wire interface cable consists of 64 individual wires. Each wire
runs directly from a test point to a fixture pin. It is less expensive than
the ribbon cable solution.
Ribbon cables neatly deliver test points from a NX Tester to Terminal Block
Interfaces. Fixture pins are wired to the Terminal Block Interface by screw
terminals. Should a fixture block require maintenance, it can be unscrewed
and replaced with a substitute in seconds. |
| |
|
 |
 |
| Discrete
Wire |
Terminal
Block |
|
| |
|
| |
|
| |
|
